Q Active - Q. Can I connect a turntable fitted with a moving coil (MC) cartridge as I can only see moving magnet (MM) mentioned?
Although the RCA toggle switch shows an MM (moving magnet) position on the hub, should you have a turntable equipped with a moving coil (MC) you will require and a phono pre-amp that would sit between the turntable and the Hub ensuring that the RCA toggle switch is set to 'LINE'. Please note, some turntables are now equipped with phono stages actually built into them and have a switch on the turntable itself for selecting the cartridge type being used, these types of turntable will generally connect direct to a 'LINE' level RCA input, please consult the turntables instruction manual.
Related Articles
Q Active - Q. Why is the audio output from my turntable connected to the Hub so low?
Answer: Firstly, please check that switch by the analogue (phono) inputs on the rear of the Hub are set to MM and that you are using a Moving Magnet (MM) cartridge. Secondly, check to see if your cartridge is Moving Coil (MC), if it is, you will need ...
Q Active - Instruction Manual [ENGLISH]
Attached is the Q Active Instruction Manual in English.
Q Active Hub - LED states and what they mean.
The attached document should be used in conjunction with the supplied user manual which also contains relevant information. The document sets out the standard Q Active Hub LED states that you might see during the course of using your equipment
Q Active - Q. Will music streamed from Spotify Connect be converted to 24bit 96kHz by the Q Active hub?
Answer: The link between the Q Active hub and loudspeakers is 24bit 96kHz, so when a turntable or other analogue device is connected to the hub, it goes into a 24bit ADC which then gets fed onto the loudspeaker at 24bit 96kHz. HDMI and Optical go ...
Q Active - Q. Can I turn the LED's off on the Q Active Hub?
Answer: Although the LED's cannot be turned off permanently, it is possible to have them extinguish after 20secs of no interaction with the remote, loudspeaker touchpad and Hub buttons, but if you do use the remote or Hub buttons, the LED's will ...