Q Media M4 - Q. Does the subwoofer output on my M4 have a Low Pass Filter?

• Related Articles

• M20/M40 - Q. Does the subwoofer output have any form of filter applied to it?

  Answer: Yes, the M20 and M40 have a 2nd order low pass filter (LPF) at 300Hz applied to the subwoofer output which is also mono.

• Q Active Hub - Q. Is the subwoofer pre-out full bandwidth mono or low pass?

  Answer: The 'Sub-Out' is an optional feed to connect a separate subwoofer to the system. This output uses a second order low pass-filter set to  -6dB @ 450Hz. A connected subwoofer may be used to extend the response of the system to include ...

• Q Acoustics Q B12 Active Subwoofer User Manual

  Attached are the instructions for the setup, use and care of your Q Acoustics Q B12 Active Subwoofer. Note: Unauthorised redistribution, publication online or otherwise of the attached documentation and images are protected under copyright.

• Q Media - Q. I have my Q Media system connected via analogue to the TV headphone out, but the system goes into standby after a short time?

  Answer: If you are connecting your Q Media system via it's analogue input to the headphone output of a TV, please ensure the TV's volume is set to high as lower volume settings reduce the signal being input, and the Q Media system will struggle to ...

• Q. I have a stereo integrated amplifier with no 'sub-out' , but it does have 'stereo out' or 'pre-out', can I connect a subwoofer?

  Answer: Some earlier and current stereo integrated amplifiers will not be equipped with a dedicated subwoofer output, but may have a 'stereo out' or 'pre-out' that can be utilised. The main difference between a 'sub out' or LFE and that of 'Pre' or ...